Čeština
Fóra
Uživatelé
MadMax
Aktivita
 
Notifications
Clear all
MadMax
MadMax
Skupina: Registrovaný
Přidal se: 2021/03/27
Active Member
1
Profile Aktivita
Wow. And here I thought it was fun. Silly me.

In forum General discussion, announcements and releases

 před 2 years
So you're saying that no one should upload a make that they ...

In forum General discussion, announcements and releases

 před 2 years
@matt-boyer Just to be clear, I never scaled any models to m...

In forum General discussion, announcements and releases

 před 2 years
So it was certainly not my intent to cheat the Prusameter sy...

In forum General discussion, announcements and releases

 před 2 years
Thanks, I wasn't sure where to report it.

In forum PrusaSlicer

 před 3 years
PS 2.4.0 Bug With Negative Volume

In forum PrusaSlicer

 před 3 years
Aha and Eureka. It turns out either by design, oversight or ...

In forum PrusaSlicer

 před 4 years
@neophyl That is certainly the behavior I'm used to and have...

In forum PrusaSlicer

 před 4 years
@antonio-da-catania Grazie Antonio. This did turn out to be ...

In forum PrusaSlicer

 před 4 years
@antonio-da-catania Both are Windows 10 x64 computers runnin...

In forum PrusaSlicer

 před 4 years
Why does the console open when I open a PS .3mf project?

In forum PrusaSlicer

 před 4 years
I slowed down acceleration from 1000 to 700 and lowered jerk...

In forum Assembly and first prints troubleshooting

 před 4 years
The print turned out much better when only printing one cube...

In forum Assembly and first prints troubleshooting

 před 4 years
Thanks for the reply @JoanTabb. It's a good suggestion. I ch...

In forum Assembly and first prints troubleshooting

 před 4 years
Strange Problem - Layer shift only on top and bottom layers

In forum Assembly and first prints troubleshooting

 před 4 years
Share: