Notifications
Clear all
MADhorseKD
MADhorseKD
Group: Registered
Joined: 2017/09/17
Active Member
1
Wellp,Sorry to say, no dice. Same issues yet again.I recentl...

In forum Hardware, firmware and software help

4 years ago
Hey guys, Sorry to necro this post, but i might have an inte...

In forum Hardware, firmware and software help

4 years ago
Hi Robert, Interesting project 🙂 Though the only thing i fi...

In forum Improvements (Archive)

5 years ago
Quick swapping out extruders/hotends

In forum Improvements (Archive)

5 years ago
Well, the issue has re-emerged on a more detailed setting......

In forum Hardware, firmware and software help

6 years ago
Hey guys, So the new 1.75mm heatbreak arrived and installed ...

In forum Hardware, firmware and software help

6 years ago
Going to try buying a new heatbreak and fans and what not. I...

In forum Hardware, firmware and software help

6 years ago
Right :s Terrible news Woke up today only to find that the p...

In forum Hardware, firmware and software help

6 years ago
Hi Guys, So switched out the nozzle to the 0.4mm one that ...

In forum Hardware, firmware and software help

6 years ago
Well...Wouldn't you know it, just as i was typing 'Thunk.......

In forum Hardware, firmware and software help

6 years ago
heyas @tim-m30 , Just did the 200mm test, not a jam or clog...

In forum Hardware, firmware and software help

6 years ago
Hi Tim, Typing this in between my work, so may not be as re...

In forum Hardware, firmware and software help

6 years ago
Hi Tim,I have never used any of the above in terms of materi...

In forum Hardware, firmware and software help

6 years ago
Heyas Tim,See below for my first layer ;)Like, perfect, smoo...

In forum Hardware, firmware and software help

6 years ago
Hi Vojtech, Like i mentioned earlier, i get pretty anal abou...

In forum Hardware, firmware and software help

6 years ago
Hey Tim,Only just been able to get back to you (the site see...

In forum Hardware, firmware and software help

6 years ago
Heyas Tim, Thanks for the reply. 1. Mhm, was present at ...

In forum Hardware, firmware and software help

6 years ago
Heyas, Thanks for the reply. With the steel one i've been ...

In forum Hardware, firmware and software help

6 years ago
i3 Mk2S Extruder gear/motor clicking

In forum Hardware, firmware and software help

6 years ago
Share: