Prusa3D Forum

Notifications

Clear all

Madchiller

Grupa: Zarejestrowany

Dołączył: 2017/07/23

Active Member

	I’m also looking into this issue atm.. I have very tiny gaps... In forum How do I print this? (Printing help)	6 years temu
	If you have the slotted belt holder on your bed you should b... In forum Others (Archive)	8 years temu
	The biggest fail I have had was the Y axis motor mount. Spec... In forum Others (Archive)	8 years temu
	I also noticed some strangeness with xyz calibration. My tw... In forum Others (Archive)	8 years temu
	Im starting to think the same thing. possible firmware issue... In forum Others (Archive)	8 years temu
	Ok. Potentially solved, I did two things. Upped the vol... In forum Others (Archive)	8 years temu
	So i just ran this procedure on my 2nd machine, It worked p... In forum Others (Archive)	8 years temu
	I currently get bed thermal runaway when trying to PID Autot... In forum Others (Archive)	8 years temu
	This is the best print so far after nozzle change and calibr... In forum Others (Archive)	8 years temu
	Need help troubleshooting this print error.. In forum Others (Archive)	8 years temu
	This happened to both of my machine within days of each oth... In forum Others (Archive)	8 years temu
	I checked the connection at the Rambo and felt it for heat. ... In forum Others (Archive)	8 years temu
	Bed Thermal Runaway while Attempting Bed PID Autotune In forum Others (Archive)	8 years temu

Statystyki Forum

585 Fora

68.2 K Tematy

477.6 K Posty

12 Online

75.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte