Čeština
Fóra
Uživatelé
Mabau
Aktivita
 
Notifications
Clear all
Mabau
Mabau
Skupina: Registrovaný
Přidal se: 2016/07/10
Trusted Member
3
Profile Aktivita
My guess is that the bondtech extruders with 1.8° steppers j...

In forum Others (Archive)

 před 7 years
How to measure heatbreak diameter without pro-tools!

In forum Others (Archive)

 před 7 years
I'm confused - Does the MMU replace the direct drive head an...

In forum Others (Archive)

 před 7 years
When the steppers hobbed bolt grabs the filament tip and sta...

In forum Others (Archive)

 před 7 years
This system is over-constraint Definately. However, I appre...

In forum Others (Archive)

 před 7 years
It will work. I used 0.15mm nozzle in single mode with PLA. ...

In forum Others (Archive)

 před 7 years
I had that problem too a few weeks ago. Also because of the ...

In forum Prusa i3 kit (Archive)

 před 7 years
I'm also working on this, with my not-MMU i3MK2. See here, b...

In forum Others (Archive)

 před 7 years
The MMU can only go down to 0.15mm. (People have experiment ...

In forum Others (Archive)

 před 7 years
Hi, same problem here. It even melted the cables. My soluti...

In forum Others (Archive)

 před 7 years
Hi. Look here for how to increase z-height - and not only b...

In forum Others (Archive)

 před 7 years
Just to understand better, did you use longer z axis rods? Y...

In forum Improvements (Archive)

 před 7 years
Does it mean that as long as the z axis motors have a long s...

In forum Improvements (Archive)

 před 7 years
I took some sleep... back again! Well, the news are good: I...

In forum Improvements (Archive)

 před 7 years
30% more build volume: 26 cm build height! WORKING

In forum Improvements (Archive)

 před 7 years
Hello there! Today I stumbled over a little issue with slic...

In forum Software (Archive)

 před 8 years
Stránka 4 / 4
Share: