Français
Forums
Membres
Mabau
Activité
 
Notifications
Clear all
Mabau
Mabau
Groupe: Enregistré
A(ont) rejoint: 2016/07/10
Trusted Member
3
Profil Activité
My guess is that the bondtech extruders with 1.8° steppers j...

Dans le forum Others (Archive)

 il y a 7 years
How to measure heatbreak diameter without pro-tools!

Dans le forum Others (Archive)

 il y a 7 years
I'm confused - Does the MMU replace the direct drive head an...

Dans le forum Others (Archive)

 il y a 7 years
When the steppers hobbed bolt grabs the filament tip and sta...

Dans le forum Others (Archive)

 il y a 7 years
This system is over-constraint Definately. However, I appre...

Dans le forum Others (Archive)

 il y a 7 years
It will work. I used 0.15mm nozzle in single mode with PLA. ...

Dans le forum Others (Archive)

 il y a 7 years
I had that problem too a few weeks ago. Also because of the ...

Dans le forum Prusa i3 kit (Archive)

 il y a 7 years
I'm also working on this, with my not-MMU i3MK2. See here, b...

Dans le forum Others (Archive)

 il y a 7 years
The MMU can only go down to 0.15mm. (People have experiment ...

Dans le forum Others (Archive)

 il y a 7 years
Hi, same problem here. It even melted the cables. My soluti...

Dans le forum Others (Archive)

 il y a 7 years
Hi. Look here for how to increase z-height - and not only b...

Dans le forum Others (Archive)

 il y a 7 years
Just to understand better, did you use longer z axis rods? Y...

Dans le forum Improvements (Archive)

 il y a 7 years
Does it mean that as long as the z axis motors have a long s...

Dans le forum Improvements (Archive)

 il y a 7 years
I took some sleep... back again! Well, the news are good: I...

Dans le forum Improvements (Archive)

 il y a 7 years
30% more build volume: 26 cm build height! WORKING

Dans le forum Improvements (Archive)

 il y a 7 years
Hello there! Today I stumbled over a little issue with slic...

Dans le forum Software (Archive)

 il y a 8 years
Page 4 / 4
Partager :