Lynn – Aktywność – Prusa3D Forum

Notifications

Clear all

Lynn

Grupa: Zarejestrowany

Dołączył: 2019/09/17

Estimable Member

	I appreciate the thought, but after speaking with the devs, ... In forum PrusaSlicer	5 years temu
	3/24/20 So far I have made about 20 attempts to slice and pr... In forum PrusaSlicer	5 years temu
	Most resent attempts 3/24/20 Ok I took an STL file, sliced i... In forum PrusaSlicer	5 years temu
	I saved the gcode file as a TXT as the gcode file was filter... In forum PrusaSlicer	5 years temu
	Printer resets at 1mm print height after installing PrusaSli... In forum PrusaSlicer	5 years temu
	I do understand the concept of over tightening and it's cons... In forum Hardware, firmware and software help	5 years temu
	I too have this question. After using this printer for 7 mo... In forum User mods - OctoPrint, enclosures, nozzles, ...	5 years temu
	The X axis does move smoothly, with no catching and no chang... In forum Hardware, firmware and software help	5 years temu
	Printer fails x axis length self test. The end of a long lis... In forum Hardware, firmware and software help	5 years temu
	@tim-m30 Will do... Thanks In forum Print tips (Archive)	5 years temu
	'aka' jam nuts, got that straight. All your points of conta... In forum Print tips (Archive)	5 years temu
	I am currently on a quest to locate the gremlin. I tried pr... In forum Print tips (Archive)	5 years temu
	Z-axis failure In forum Print tips (Archive)	5 years temu

Strona 12 / 12 Wstecz

Statystyki Forum

565 Fora

63.6 K Tematy

446.3 K Posty

21 Online

69 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte