Lynn – Aktivita – Prusa3D Forum

Notifications

Clear all

Lynn

Skupina: Registrovaný

Přidal se: 2019/09/17

Estimable Member

	I appreciate the thought, but after speaking with the devs, ... In forum PrusaSlicer	před 5 years
	3/24/20 So far I have made about 20 attempts to slice and pr... In forum PrusaSlicer	před 5 years
	Most resent attempts 3/24/20 Ok I took an STL file, sliced i... In forum PrusaSlicer	před 5 years
	I saved the gcode file as a TXT as the gcode file was filter... In forum PrusaSlicer	před 5 years
	Printer resets at 1mm print height after installing PrusaSli... In forum PrusaSlicer	před 5 years
	I do understand the concept of over tightening and it's cons... In forum Hardware, firmware and software help	před 5 years
	I too have this question. After using this printer for 7 mo... In forum User mods - OctoPrint, enclosures, nozzles, ...	před 5 years
	The X axis does move smoothly, with no catching and no chang... In forum Hardware, firmware and software help	před 5 years
	Printer fails x axis length self test. The end of a long lis... In forum Hardware, firmware and software help	před 5 years
	@tim-m30 Will do... Thanks In forum Print tips (Archive)	před 5 years
	'aka' jam nuts, got that straight. All your points of conta... In forum Print tips (Archive)	před 5 years
	I am currently on a quest to locate the gremlin. I tried pr... In forum Print tips (Archive)	před 5 years
	Z-axis failure In forum Print tips (Archive)	před 5 years

Stránka 12 / 12 Předchozí

Fórum Statistiky

565 Fóra

63.6 K Témata

446.3 K Příspěvky

20 Online

69 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed