Notifications
Clear all
lumbeecheraw75
Skupina: Registrovaný
Přidal se: 2021/07/22
Active Member
1
| I think this was the screw that I tightened. The screw that ... | před 4 years | |
| after reviewing these, i think i found the cause. Looks like... | před 4 years | |
| reviewing these | před 4 years | |
| is this z banding? loose (or too tight?) x belt? | před 4 years | |
| I figured it out. Bolt holding tension on Y belt was loose. ... | před 4 years | |
| last week on right, left is today | před 4 years | |
| prints changed after 2 days of not printing. Any ideas? | před 4 years |