Prusa3D Forum

Notifications

Clear all

Lukasz

Groupe: Enregistré

A(ont) rejoint: 2022/04/22

Active Member

	No idea why the file didn't attach. Trying again. Than... Dans le forum PrusaSlicer	il y a 2 years
	Prusa Slicer removing top surface no matter what. Dans le forum PrusaSlicer	il y a 2 years
	Prusa Slicer removing top surface no matter what. Dans le forum PrusaSlicer	il y a 2 years
	So yesterday I tried heating the bed heater and putting just... Dans le forum Hardware, firmware and software help	il y a 3 years
	Thank you for the reply. I haven't got a satin sheet(just s... Dans le forum Hardware, firmware and software help	il y a 3 years
	Turning upside down c-stick treated print bed? Dans le forum Hardware, firmware and software help	il y a 3 years
	I use 0.1mm layers to get better quality dimension-wise. If ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Strange single layer shift. Dans le forum Hardware, firmware and software help	il y a 3 years
	Thank you for the reply. However I've since overwritten the ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I do a lot of printing with lw-pla (esun brand) and I use pr... Dans le forum How do I print this? (Printing help)	il y a 3 years
	What causes this? Dans le forum How do I print this? (Printing help)	il y a 3 years
	Thank you for the reply. I'll add the project file later as ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I can't tell why the 3d printing services companies charge w... Dans le forum General discussion, announcements and releases	il y a 3 years
	Surface quality under a part (using supports). Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

585 Forums

68.4 K Sujets

478.9 K Messages

12 En-ligne

76.4 K Membres

Le dernier des messages: 3D Jake ASA print settings Notre nouveau membre: rhn Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé