|
No idea why the file didn't attach. Trying again.
Than... In forum PrusaSlicer |
1 year ago |
|
Prusa Slicer removing top surface no matter what. In forum PrusaSlicer |
1 year ago |
|
Prusa Slicer removing top surface no matter what. In forum PrusaSlicer |
1 year ago |
|
So yesterday I tried heating the bed heater and putting just... In forum Hardware, firmware and software help |
2 years ago |
|
Thank you for the reply. I haven't got a satin sheet(just s... In forum Hardware, firmware and software help |
2 years ago |
|
Turning upside down c-stick treated print bed? In forum Hardware, firmware and software help |
2 years ago |
|
I use 0.1mm layers to get better quality dimension-wise. If ... In forum How do I print this? (Printing help) |
2 years ago |
|
Strange single layer shift. In forum Hardware, firmware and software help |
2 years ago |
|
Thank you for the reply. However I've since overwritten the ... In forum How do I print this? (Printing help) |
2 years ago |
|
I do a lot of printing with lw-pla (esun brand) and I use pr... In forum How do I print this? (Printing help) |
2 years ago |
|
What causes this? In forum How do I print this? (Printing help) |
2 years ago |
|
Thank you for the reply. I'll add the project file later as ... In forum How do I print this? (Printing help) |
3 years ago |
|
I can't tell why the 3d printing services companies charge w... In forum General discussion, announcements and releases |
3 years ago |
|
Surface quality under a part (using supports). In forum How do I print this? (Printing help) |
3 years ago |
