Notifications
Clear all
Louis
Skupina: Registrovaný
Přidal se: 2018/03/11
Eminent Member
2
|
I’ll try cleaning the sensor, but turning off the sensor see... In forum Hardware, firmware and software help |
před 7 years | |
|
Unwanted filament change request In forum Hardware, firmware and software help |
před 7 years | |
|
I use alcohol wipes before each print. But I’ll rerun the ca... In forum How do I print this? (Printing help) |
před 7 years | |
|
PLA lifting from bed in one corner In forum How do I print this? (Printing help) |
před 7 years | |
|
Both are PLA.
I was able to get a successful Benchy when s... In forum Others (Archive) |
před 7 years | |
|
Yes, the settings is at a negative value. I’ll re attempt wi... In forum Others (Archive) |
před 7 years | |
|
First layer seems okay on the benchy and the other prints I’... In forum Others (Archive) |
před 7 years | |
|
Benchy failure In forum Others (Archive) |
před 7 years |
Stránka 2 / 2
Předchozí