Notifications
Clear all
Louis
Groupe: Enregistré
A(ont) rejoint: 2018/03/11
Eminent Member
2
|
I’ll try cleaning the sensor, but turning off the sensor see... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Unwanted filament change request Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
I use alcohol wipes before each print. But I’ll rerun the ca... Dans le forum How do I print this? (Printing help) |
il y a 7 years | |
|
PLA lifting from bed in one corner Dans le forum How do I print this? (Printing help) |
il y a 7 years | |
|
Both are PLA.
I was able to get a successful Benchy when s... Dans le forum Others (Archive) |
il y a 7 years | |
|
Yes, the settings is at a negative value. I’ll re attempt wi... Dans le forum Others (Archive) |
il y a 7 years | |
|
First layer seems okay on the benchy and the other prints I’... Dans le forum Others (Archive) |
il y a 7 years | |
|
Benchy failure Dans le forum Others (Archive) |
il y a 7 years |
Page 2 / 2
Précédent