Notifications
Clear all
lnjustin
Skupina: Registrovaný
Přidal se: 2022/12/21
Eminent Member
2
| As an example, could I just put use the below gcode for afte... | před 3 years | |
| Keep Mini on and connected, but no heat? | před 3 years | |
| Any way to add a pause (and turn fan off, set tool to 0, but... | před 3 years | |
|
My novice eye thought it turned out quite good. Had to clean... In forum How do I print this? (Printing help) |
před 3 years | |
|
Ah. I was afraid of that. Way too impractical then. Good poi... In forum How do I print this? (Printing help) |
před 3 years | |
| I think the answer is yes, it seems. At least according to t... | před 3 years | |
|
Thanks! I’ll give it a whirl…lots to learn In forum How do I print this? (Printing help) |
před 3 years | |
| Rasp Pi 4B 2GB ok for octoprint? | před 3 years | |
|
Print Eyes Different Color? In forum How do I print this? (Printing help) |
před 3 years | |
| Thanks for everyone's help. Lowered the nozzle a lot. Like .... | před 3 years | |
| Thanks for your responses. Very helpful! The bottom of the b... | před 3 years | |
| Benchy Failure Help? | před 3 years |
Stránka 2 / 2
Předchozí