Notifications
Clear all
lnjustin
Skupina: Registrovaný
Přidal se: 2022/12/21
Eminent Member
2
As an example, could I just put use the below gcode for afte... | před 2 years | |
Keep Mini on and connected, but no heat? | před 2 years | |
Any way to add a pause (and turn fan off, set tool to 0, but... | před 2 years | |
My novice eye thought it turned out quite good. Had to clean... In forum How do I print this? (Printing help) |
před 2 years | |
Ah. I was afraid of that. Way too impractical then. Good poi... In forum How do I print this? (Printing help) |
před 2 years | |
I think the answer is yes, it seems. At least according to t... | před 2 years | |
Thanks! I’ll give it a whirl…lots to learn In forum How do I print this? (Printing help) |
před 2 years | |
Rasp Pi 4B 2GB ok for octoprint? | před 2 years | |
Print Eyes Different Color? In forum How do I print this? (Printing help) |
před 2 years | |
Thanks for everyone's help. Lowered the nozzle a lot. Like .... | před 2 years | |
Thanks for your responses. Very helpful! The bottom of the b... | před 2 years | |
Benchy Failure Help? | před 2 years |
Stránka 2 / 2
Předchozí