|
That isn't what your earlier photo shows. Your latest photo... In forum Hardware, firmware and software help |
5 years ago |
|
That is what i did. I just made sure when unscrewing the noz... In forum Hardware, firmware and software help |
5 years ago |
|
There is a lot of filament flowing out while the nozzle is h... In forum Hardware, firmware and software help |
5 years ago |
|
I reassembled and made sure to leave a gap. In forum Hardware, firmware and software help |
5 years ago |
|
Never mind. It stopped printing after half an hour. In forum Hardware, firmware and software help |
5 years ago |
|
So i've lowered my temperature to 200 °C and actually get us... In forum Hardware, firmware and software help |
5 years ago |
|
Posted by: bobstro That cabling DEFINITELY looks to be hangi... In forum Hardware, firmware and software help |
5 years ago |
|
My filament is the default silver/gray one that comes with t... In forum Hardware, firmware and software help |
5 years ago |
|
I'm at loss now. I cleaned all parts of the hotend, reassemb... In forum Hardware, firmware and software help |
5 years ago |
|
I cleaned the nozzle, block and heat break with a kitchen bl... In forum Hardware, firmware and software help |
5 years ago |
|
Thanks for the advice. I followed they guide step by step bu... In forum Hardware, firmware and software help |
5 years ago |
|
Oozing after Hotend disassembly. In forum Hardware, firmware and software help |
5 years ago |
