Avisos
Vaciar todo
les.b
Grupo: Registrado
Registrado: 2017/08/10
Active Member
1
| Thanks Guys, Yes i realized what i had done, and now have a ... | hace 6 years | |
|
Thanks Joan,
Will try a new nozel but not concerned, only an... En el foro Hardware, firmware and software help |
hace 6 years | |
|
Hi Joan,
Thanks for the reply. Just to answer your questions... En el foro Hardware, firmware and software help |
hace 6 years | |
|
Nozel Outputing filament after temps reached En el foro Hardware, firmware and software help |
hace 6 years | |
|
Thanks Guys,
I didnt think it was much but all of this is ne... En el foro Others (Archive) |
hace 7 years | |
|
Model leaving outline print on bed after printing En el foro Others (Archive) |
hace 7 years | |
|
Found my problem, Z adjustment ,had to change from .225mm to... En el foro Others (Archive) |
hace 7 years | |
|
Compensating for hole size inaccuracie En el foro Software (Archive) |
hace 7 years | |
|
Thanks Mavu,
Tried finger nails but this just made a shiny m... En el foro Others (Archive) |
hace 7 years | |
|
Removing PLA remnants from I3 MK2s PEI sheet En el foro Others (Archive) |
hace 7 years |