Notifications
Clear all
les.b
Group: Registered
Joined: 2017/08/10
Active Member
1
| Thanks Guys, Yes i realized what i had done, and now have a ... | 6 years ago | |
|
Thanks Joan,
Will try a new nozel but not concerned, only an... In forum Hardware, firmware and software help |
6 years ago | |
|
Hi Joan,
Thanks for the reply. Just to answer your questions... In forum Hardware, firmware and software help |
6 years ago | |
|
Nozel Outputing filament after temps reached In forum Hardware, firmware and software help |
6 years ago | |
|
Thanks Guys,
I didnt think it was much but all of this is ne... In forum Others (Archive) |
7 years ago | |
|
Model leaving outline print on bed after printing In forum Others (Archive) |
7 years ago | |
|
Found my problem, Z adjustment ,had to change from .225mm to... In forum Others (Archive) |
7 years ago | |
|
Compensating for hole size inaccuracie In forum Software (Archive) |
7 years ago | |
|
Thanks Mavu,
Tried finger nails but this just made a shiny m... In forum Others (Archive) |
7 years ago | |
|
Removing PLA remnants from I3 MK2s PEI sheet In forum Others (Archive) |
7 years ago |