Prusa3D Forum

Notifiche

Cancella tutti

Leon

Gruppo: Registrato

Registrato: 2022/03/01

Active Member

	The gear on the x motor was loose and slipping. Only needed... Nel forum Hardware, firmware and software help	3 years fa
	My prior forum post was premature. Although, cutting the zi... Nel forum Hardware, firmware and software help	3 years fa
	One of the zip ties on the cable to the extruder was not cut... Nel forum Hardware, firmware and software help	3 years fa
	Read my post First Layer Haywire. I tried printing a new Gc... Nel forum Hardware, firmware and software help	3 years fa
	I started having similar problems with the first layer, late... Nel forum Hardware, firmware and software help	3 years fa
	First Layer Haywire Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

565 Forum

64.6 K Discussioni

452.2 K Post

22 Online

71.2 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso