Prusa3D Forum

Notifications

Clear all

Leapnlarry

Groupe: Enregistré

A(ont) rejoint: 2016/09/27

Active Member

	I am so pissed, i ordered mine on feb 27th so i guess im out... Dans le forum General discussion, announcements and releases	il y a 2 years
	I pulled and checked both ribbon cables at both ends but sti... Dans le forum PrusaSlicer	il y a 3 years
	here are two photos of the screen flashing one blank no ligh... Dans le forum PrusaSlicer	il y a 3 years
	here are two photos of the screen flashing one blank no ligh... Dans le forum PrusaSlicer	il y a 3 years
	mk 2.5s printer died after updating to the new firmware Dans le forum PrusaSlicer	il y a 3 years
	Z axis going out of calibration, prints failing Dans le forum General discussion, announcements and releases	il y a 3 years
	after getting on prusa chat with Greyson, he suggested that ... Dans le forum Others (Archive)	il y a 9 years
	the part fan never comes on i have it set for off on abs. b... Dans le forum Others (Archive)	il y a 9 years
	I don't think it is a g code problem, I am very careful abou... Dans le forum Others (Archive)	il y a 9 years
	I fixed my issue by moving the nuts on the y axis nuts a few... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Printer Freezes in middle of print Dans le forum Others (Archive)	il y a 9 years
	i am getting the same error message at the end of xyz calibr... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	thanks for your posts. I was lining up pin one with the red... Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.4 K Messages

12 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé