Prusa3D Forum

Notifications

Clear all

Leapnlarry

Group: Registered

Joined: 2016/09/27

Active Member

	I am so pissed, i ordered mine on feb 27th so i guess im out... In forum General discussion, announcements and releases	2 years ago
	I pulled and checked both ribbon cables at both ends but sti... In forum PrusaSlicer	2 years ago
	here are two photos of the screen flashing one blank no ligh... In forum PrusaSlicer	2 years ago
	here are two photos of the screen flashing one blank no ligh... In forum PrusaSlicer	2 years ago
	mk 2.5s printer died after updating to the new firmware In forum PrusaSlicer	2 years ago
	Z axis going out of calibration, prints failing In forum General discussion, announcements and releases	2 years ago
	after getting on prusa chat with Greyson, he suggested that ... In forum Others (Archive)	8 years ago
	the part fan never comes on i have it set for off on abs. b... In forum Others (Archive)	8 years ago
	I don't think it is a g code problem, I am very careful abou... In forum Others (Archive)	8 years ago
	I fixed my issue by moving the nuts on the y axis nuts a few... In forum Prusa i3 kit (Archive)	8 years ago
	Printer Freezes in middle of print In forum Others (Archive)	8 years ago
	i am getting the same error message at the end of xyz calibr... In forum Prusa i3 kit (Archive)	8 years ago
	thanks for your posts. I was lining up pin one with the red... In forum Prusa i3 kit (Archive)	8 years ago

Forum Statistics

566 Forums

63.2 K Topics

444.2 K Posts

21 Online

68.1 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed