LaPointe – Activité – Prusa3D Forum

Notifications

Clear all

LaPointe

Groupe: Modérateur

A(ont) rejoint: 2017/04/30

Titre: French moderator and translator Moderator

	I don't really see a reason... Dans le forum Others (Archive)	il y a 8 years
	I never checked those values before since the XYZ calibratio... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	You should contact them through the live chat on the shop we... Dans le forum Others (Archive)	il y a 8 years
	I found this one yesterday: Printed in two parts and then g... Dans le forum Print tips (Archive)	il y a 8 years
	I have two Y corners that have cracked a bit, but I have lef... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	This is indeed a good question! In my opinion, the Mk2S shou... Dans le forum Others (Archive)	il y a 8 years
	You should contact the support, this may be a faulty PINDA p... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Have you calibrated your extruder? (Read this if not: ) It s... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Impresive! Is it your own design? Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	And is this only one body? It seems that some parts of the m... Dans le forum Print tips (Archive)	il y a 8 years
	Yes but the mesh is obviously not fine... With which softwar... Dans le forum Print tips (Archive)	il y a 8 years
	Ok thanks, so this is even pre-S, your reassure me :mrgreen... Dans le forum Others (Archive)	il y a 8 years
	Design change on the Z axis ? Dans le forum Others (Archive)	il y a 8 years
	Printing PLA at high ambiant temperature can lead to filamen... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Unmount the cover and simply turn the heatsink. Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	A flat Draudi Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Nice! Thanks a lot for your work again. I've done my firsts ... Dans le forum Improvements (Archive)	il y a 8 years
	I've had the same issue and some lubrification helped. The l... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Please read this post and its first 5 pages at least for the... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Using a feeler gauge is the safest way in my opinion, and it... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Page 25 / 26 Précédent Suivant

Statistiques du forum

585 Forums

68.2 K Sujets

477.7 K Messages

11 En-ligne

75.9 K Membres

Le dernier des messages: Y-axis calibration failure, new kit Notre nouveau membre: mnentwig Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé