Notifications
Clear all
lantis
Skupina: Registrovaný
Přidal se: 2022/04/29
Active Member
1
| Maybe I'm just misunderstanding the concept of an extruder a... | před 2 years | |
| I did that, but then the gear resists to move. And it does t... | před 2 years | |
| Bondtech Extruder Upgrade - Design Error? | před 2 years | |
|
I've switched to a Bondtech extruder and an E3D Revo Micro h... In forum Hardware, firmware and software help |
před 3 years | |
|
Popping Noise at Hotend and Extrusion Skips In forum Hardware, firmware and software help |
před 3 years |