Kwaad2 – Activité – Prusa3D Forum

Notifications

Clear all

Kwaad2

Groupe: Enregistré

A(ont) rejoint: 2017/12/01

Honorable Member

	My guess is it is not as heavy as the old one, for one you h... Dans le forum Others (Archive)	il y a 8 years
	Question, that seems heavier/bulkier than I thought. Will t... Dans le forum Others (Archive)	il y a 8 years
	I don't think it would cause any vibrations or anything, the... Dans le forum Others (Archive)	il y a 8 years
	I'm gonna leave this here. Enjoy. Dans le forum Others (Archive)	il y a 8 years
	I just finished two of the same print, they were both 30 sma... Dans le forum Others (Archive)	il y a 8 years
	I think they've been doing development on other firmware ver... Dans le forum General discussion, announcements and releases	il y a 8 years
	0.400 or -0.400? I am running at -0.720 right now, I was at... Dans le forum Others (Archive)	il y a 8 years
	There is no blind support from my side. I like the open sour... Dans le forum Others (Archive)	il y a 8 years
	I am actually very interested in what is said on this. I kn... Dans le forum Others (Archive)	il y a 8 years
	I figured out it has something to do with me converting file... Dans le forum Others (Archive)	il y a 8 years
	Honestly ... this kind of conversation you can have with any... Dans le forum Others (Archive)	il y a 8 years
	2018 Midwest RepRap Festival (THIS WEEKEND) Dans le forum Others (Archive)	il y a 8 years
	So I almost always print in PETG. I'm afraid to print with ... Dans le forum Others (Archive)	il y a 8 years
	The one the printer is supposed to come with is the textured... Dans le forum Others (Archive)	il y a 8 years
	Going with the PEI sheet is best IMO. The powder coated beds... Dans le forum Others (Archive)	il y a 8 years
	WAY too high. Looks almost .25 to.5mm too high. (you need a... Dans le forum Others (Archive)	il y a 8 years
	That looks funny but i would not have want the printer to pa... Dans le forum Others (Archive)	il y a 8 years
	I don't use a camera mount. I just sit it next to the printe... Dans le forum Others (Archive)	il y a 8 years
	Thanks Sean. I will try this. I had not previously done this... Dans le forum Others (Archive)	il y a 8 years
	When I was looking to buy some NinjaFlex a while back, I not... Dans le forum Others (Archive)	il y a 8 years

Page 22 / 29 Précédent Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.1 K Messages

11 En-ligne

76.1 K Membres

Le dernier des messages: PC printing on Core One Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé