|
I'm in touch with Prusa Support, unfortunately it takes quit... In forum Hardware, firmware and software help |
3 weeks ago |
|
Closer up image. Same artefact is on the support, leading me... In forum Hardware, firmware and software help |
1 month ago |
|
Thanks! The shroud seems (optically at least) fine and unhar... In forum Hardware, firmware and software help |
1 month ago |
|
I'll try PETG first before ordering PCCF (I suspect I need a... In forum Hardware, firmware and software help |
1 month ago |
|
Hi! I usually slice the models I print myself, sometimes I ... In forum Hardware, firmware and software help |
1 month ago |
|
This was with the default 0.4mm nozzle. Not sure what you me... In forum Hardware, firmware and software help |
1 month ago |
|
Hi Diem!I clean them with water and soap occasionally, and w... In forum Hardware, firmware and software help |
1 month ago |
|
This is post-blob, made sure the nozzle was clean and secure... In forum Hardware, firmware and software help |
1 month ago |
|
I managed to carefully remove the spilled plastic from aroun... In forum Hardware, firmware and software help |
1 month ago |
|
Core One + Print Fails (Bed adhesion? Nozzle positioning?) In forum Hardware, firmware and software help |
1 month ago |
