Prusa3D Forum

Notifiche

Cancella tutti

kryyp

Gruppo: Registrato

Registrato: 2021/03/24

Active Member

	@cwbullet Checked cable and found a small broken part on the... Nel forum Hardware, firmware and software help	4 years fa
	Mintemp bed error Nel forum Hardware, firmware and software help	4 years fa
	@bobstro Understand, yeah they did. Can still see them but b... Nel forum How do I print this? (Printing help)	4 years fa
	@bobstro Moved it to rear, seems to work fine. Only wonder w... Nel forum How do I print this? (Printing help)	4 years fa
	@bobstro Ok, thanks. I will try moving it and see if it's en... Nel forum How do I print this? (Printing help)	4 years fa
	@diem It's FilamentPM with 2 perimeters(Vertical shells). Ev... Nel forum How do I print this? (Printing help)	4 years fa
	Retraction settings? What do I change in slicer to get rid o... Nel forum How do I print this? (Printing help)	4 years fa

Statistiche Forum

559 Forum

62.9 K Discussioni

442.9 K Post

19 Online

67.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso