Prusa3D Forum

Notifications

Clear all

Kristof Ulburghs

Groupe: Enregistré

A(ont) rejoint: 2016/02/04

Active Member

	It looks like warping forces that are too much for the mater... Dans le forum Print tips (Archive)	il y a 9 years
	Two things that really improved print to bed adhesion for me... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	This sounds like a cheap advertisement but it's true, the pr... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Peter, From my view it is a compensation for the non-fla... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I made 4 of these : And put them on all corners. What a di... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	In my case sliding and rubbing a bolt through the hole was n... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Peter, So I cleaned the glass and put it on the PCB in s... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Peter, I have cleaned the glass just now so I don't reme... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Josef, 1. About the bolt. I took a good look and while t... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Josef, Hi Peter, Thanks for the help already. 1. I will... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Printer OK. Happy. Some issues. Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

20 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé