Prusa3D Forum

Notifiche

Cancella tutti

Kris Glover

Gruppo: Registrato

Registrato: 2020/02/16

Active Member

	Filament won't load... Nel forum How do I print this? (Printing help)	5 years fa
	would a titanium heatbreak make the filament flow more smoot... Nel forum Hardware, firmware and software help	5 years fa
	also gonna get socks for the block, but are there any other ... Nel forum Hardware, firmware and software help	5 years fa
	I did confirm those were the thermistore wires that broke lo... Nel forum Hardware, firmware and software help	5 years fa
	Would this fit? I'm still not sure I'm seeing all the wires... Nel forum Hardware, firmware and software help	5 years fa
	First catastrophe - wires pulled out Nel forum Hardware, firmware and software help	5 years fa

Statistiche Forum

565 Forum

63.8 K Discussioni

447.5 K Post

22 Online

69.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso