|
As an update, this is after another 1:10 of print, tuned int... Dans le forum Others (Archive) |
il y a 7 years |
|
I have a follow-up query.
Does the printer need to be compl... Dans le forum Others (Archive) |
il y a 7 years |
|
Didn't notice any issue. I did notice some pla filament I ha... Dans le forum Others (Archive) |
il y a 7 years |
|
Is this after a few hours printing in high power mode?
No, t... Dans le forum Others (Archive) |
il y a 7 years |
|
Slic3r - change temperature settings mid print Dans le forum Software (Archive) |
il y a 7 years |
|
With ambient temperature of 26.0'C, nozzle at 255'C (and hea... Dans le forum Others (Archive) |
il y a 7 years |
|
Since I have access to thermal imaging camera, I'm going to ... Dans le forum Others (Archive) |
il y a 7 years |
|
Doing second ABS print right now, no adjustment was required... Dans le forum Others (Archive) |
il y a 7 years |
|
Why not do the levelling before heating up things?
I conside... Dans le forum Others (Archive) |
il y a 7 years |
|
Ultimately I went with start g-code of:
M115 U3.0.11 ; tell... Dans le forum Others (Archive) |
il y a 7 years |
|
Like I said, you should turn off temp calibration and just c... Dans le forum Others (Archive) |
il y a 7 years |
|
I have switched to PLA for few prints, and they come out con... Dans le forum Others (Archive) |
il y a 7 years |
|
I have raised my PINDA probe to 1.2mm above hotend and now l... Dans le forum Others (Archive) |
il y a 7 years |
|
Something is definitely wrong, and It's start's to look to m... Dans le forum Others (Archive) |
il y a 7 years |
|
I have just re-calibrated XYZ of printer, and Z adjust reque... Dans le forum Others (Archive) |
il y a 7 years |
|
I'm using slic3r, so I suppose I can modify just about anyth... Dans le forum Others (Archive) |
il y a 7 years |
|
I am using temperature calibration which I have re-done just... Dans le forum Others (Archive) |
il y a 7 years |
|
Well now I just don't get it. I just started another ABS pri... Dans le forum Others (Archive) |
il y a 7 years |
|
Different live Z adjustments for different materials. Dans le forum Others (Archive) |
il y a 7 years |
|
Should I correct the frame?
Just be warned that making the p... Dans le forum Others (Archive) |
il y a 7 years |
