Prusa3D Forum

Notifications

Clear all

Knaz

Skupina: Registrovaný

Přidal se: 2020/12/01

Active Member

	Good day! I'm sorry, the problem was in the hot end. Thanks ... In forum PrusaSlicer	před 4 years
	I also confirm the defect described in this post: In forum PrusaSlicer	před 4 years
	Defect during printing PS 2.3 In forum PrusaSlicer	před 4 years
	@misan Thank you! In forum PrusaSlicer	před 4 years
	Very strange. This was not the case before.I set it to 19% a... In forum PrusaSlicer	před 4 years
	Thanks everyone. Yes, the area can be different. If I change... In forum PrusaSlicer	před 4 years
	@neophyl one of the 4 legs inside the box is 100% full when ... In forum PrusaSlicer	před 4 years
	incorrect slicing PrusaSlicer 2.3.0 In forum PrusaSlicer	před 4 years
	The length of the bridge is 5 centimeters. This is a test mo... In forum PrusaSlicer	před 4 years
	Sorry forgot to describe the defect. When printing a bridge,... In forum PrusaSlicer	před 4 years
	Incorrect calculation when printing bridges In forum PrusaSlicer	před 4 years
	@neophyl Thank you, you're right. Unfortunately, with a laye... In forum PrusaSlicer	před 4 years
	@neophyl I set the value to "3" with a layer thickness of 0.... In forum PrusaSlicer	před 4 years
	Combine infill In forum PrusaSlicer	před 4 years

Fórum Statistiky

559 Fóra

63 K Témata

443.2 K Příspěvky

20 Online

67.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed