Čeština
Fóra
Uživatelé
KLAUS
Aktivita
 
Notifications
Clear all
KLAUS
KLAUS
Skupina: Registrovaný
Přidal se: 2018/08/09
Trusted Member
3
Profile Aktivita
Help in putting together a list of spare parts to have on ha...

In forum General discussion, announcements and releases

 před 4 years
Thanks for the replies, at the time I was trying to print, I...

In forum PrusaSlicer

 před 5 years
MY MODEL IS BLUE INSTEAD OF THE USUAL GREEN AFTER I IMPORTED...

In forum PrusaSlicer

 před 5 years
@neophyl Thanks for those answers much appreciated!

In forum Hardware, firmware and software help

 před 5 years
After I have sliced a model, how can I reopen it in slicer a...

In forum Hardware, firmware and software help

 před 5 years
@steve_g Thanks for that info Steve, I'm going to order a sm...

In forum Hardware, firmware and software help

 před 5 years
What do I need to do with my printer setting If I want to sw...

In forum Hardware, firmware and software help

 před 5 years
Daniel, What glue did you use between the tufnil and the ste...

In forum How do I print this? (Printing help)

 před 6 years
Hi , I was reading this thread with interest, because I want...

In forum How do I print this? (Printing help)

 před 6 years
Can Taulman nylon Alloy 910 be printed on the textured powde...

In forum Hardware, firmware and software help

 před 6 years
Can you print Taulman 910 on the powder coated sheet

In forum How do I print this? (Printing help)

 před 6 years
Thank you Joan, and Rufus. Yes it was the extrusion width se...

In forum Hardware, firmware and software help

 před 6 years
Not see any change in preview of Slic3R after changing nozzl...

In forum Hardware, firmware and software help

 před 6 years
Stránka 3 / 3
Share: