Prusa3D Forum

Notifications

Clear all

kkarsten

Grupa: Zarejestrowany

Dołączył: 2020/04/11

Active Member

	@joantabb Thanx! I did flash the new firmware and it reporte... In forum Hardware, firmware and software help	5 years temu
	@Joan You are probably right about the blob. And I tried the... In forum Hardware, firmware and software help	5 years temu
	@joantabb sorry for my bad english: I didn't reject suggesti... In forum Hardware, firmware and software help	5 years temu
	@peter-m26 Thanks for the answer but the first layer was ok.... In forum Hardware, firmware and software help	5 years temu
	@peter-m26 Done. Did the calibration twice to be sure... Dur... In forum Hardware, firmware and software help	5 years temu
	Calibration at print start crashes In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

18 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte