Prusa3D Forum

Notifiche

Cancella tutti

Kevin

Gruppo: Registrato

Registrato: 2022/08/13

Active Member

	I can eliminate software issues. I started this on the prin... Nel forum General discussion, announcements and releases	2 years fa
	I went back to the previous slicer and moved the it to the r... Nel forum General discussion, announcements and releases	2 years fa
	I cleaned the sheet once again. Resliced with 2.5 version. ... Nel forum General discussion, announcements and releases	2 years fa
	I cleaned the sheet and changed the slicer to the older vers... Nel forum General discussion, announcements and releases	2 years fa
	I understand what you are saying but the offset is perfect. ... Nel forum General discussion, announcements and releases	2 years fa
	infill shift on one side only Nel forum General discussion, announcements and releases	2 years fa

Statistiche Forum

566 Forum

63.2 K Discussioni

444.2 K Post

22 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso