Prusa3D Forum

Notifiche

Cancella tutti

Kevin

Gruppo: Registrato

Registrato: 2022/08/13

Active Member

	I can eliminate software issues. I started this on the prin... Nel forum General discussion, announcements and releases	3 years fa
	I went back to the previous slicer and moved the it to the r... Nel forum General discussion, announcements and releases	3 years fa
	I cleaned the sheet once again. Resliced with 2.5 version. ... Nel forum General discussion, announcements and releases	3 years fa
	I cleaned the sheet and changed the slicer to the older vers... Nel forum General discussion, announcements and releases	3 years fa
	I understand what you are saying but the offset is perfect. ... Nel forum General discussion, announcements and releases	3 years fa
	infill shift on one side only Nel forum General discussion, announcements and releases	3 years fa

Statistiche Forum

585 Forum

68.1 K Discussioni

476.9 K Post

10 Online

75.8 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso