Attività
 
Notifiche
Cancella tutti
kersti.v
kersti.v
Gruppo: Registrato
Registrato: 2015/11/30
Active Member
1
Hi! Thanks for the help guys. I have installed E3D V6 full ...

Nel forum Improvements (Archive)

9 years fa
Ok, i will keep that in mind 🙂

Nel forum Improvements (Archive)

9 years fa
Thanks for the great info. I really needed that. I might jus...

Nel forum Improvements (Archive)

9 years fa
Yes i have original E3D V6 and i found out from E3D webpage ...

Nel forum Improvements (Archive)

9 years fa
Thanks for the instructions, seems like i have done it many ...

Nel forum Improvements (Archive)

9 years fa
Is this normal answer after verify? Sketch uses 120,536 byt...

Nel forum Improvements (Archive)

9 years fa
i have looked around and reinstalled arduino IDE for 10x all...

Nel forum Improvements (Archive)

9 years fa
I used your firmware source for addons and so on, but i got ...

Nel forum Improvements (Archive)

9 years fa
this is allso out dated and not working.

Nel forum Improvements (Archive)

9 years fa
How do i install this MarlinAddon? There are only files, no ...

Nel forum Improvements (Archive)

9 years fa
Im sorry to hear that. I have been trying to edit this firmw...

Nel forum Improvements (Archive)

9 years fa
I tried to change this conf file, but i cant get it from HEX...

Nel forum Improvements (Archive)

9 years fa
Thanks for response. I will try this 2 pin connector out wh...

Nel forum Improvements (Archive)

9 years fa
Are these P3 connector 12V? E3D says that it needs 5V.

Nel forum Improvements (Archive)

9 years fa
I just realized that i have to connect that ground and middl...

Nel forum Improvements (Archive)

9 years fa
Thank you so much for answering. I have been looking for thi...

Nel forum Improvements (Archive)

9 years fa
Mini-Rambo 1.3 and e3d with PT100

Nel forum Improvements (Archive)

9 years fa
Condividi: