Notifications
Clear all
Keanu
Skupina: Registrovaný
Přidal se: 2024/05/23
Active Member
1
| I canceled the print because it’s still very strange. | před 1 year | |
| does this look normal? It’s 10% infill with adaptive cubic | před 1 year | |
| With grid Is the offset Z now better? I lowered it from -1.2... | před 1 year | |
| I also tried it with 15% and it was still the same with the ... | před 1 year | |
| It’s like since last week I don’t seem to get a good surface... | před 1 year | |
| project | před 1 year | |
| Bottom and top layer very fragile | před 1 year |