Notifications
Clear all
Katang
Skupina: Registrovaný
Přidal se: 2021/03/01
Active Member
1
|
Thank you! I ended up just cutting until I could get the th... In forum Hardware, firmware and software help |
před 3 years | |
|
How long is PTFE feeder tube? (Prusa Mini) In forum Hardware, firmware and software help |
před 3 years | |
| @bobstro Yes, this was the pattern for Jeff Jordan’s “Life A... | před 5 years | |
| First thing I would check is that this screw is flush when f... | před 5 years | |
| This is what my first layer looks like. Same z adhustment s... | před 5 years | |
| First layer question | před 5 years | |
| @mrstoned Swapped in the spare piece of tube and didn't seem... | před 5 years | |
| This is what my current prints looks like: | před 5 years | |
| Filament flow issues | před 5 years |