Notifications
Clear all
Kaskelin
Skupina: Registrovaný
Přidal se: 2023/12/03
Active Member
1
|
I try to re-calibrate the sensor. I am not checked if FS ON ... In forum Hardware, firmware and software help |
před 8 months | |
|
RE: Filament changing bug? In forum Hardware, firmware and software help |
před 8 months | |
|
Do we have fix for this error? My firmware version is 5.1.3.... In forum Hardware, firmware and software help |
před 8 months | |
|
I was aware of the filament remains and try to clean sensor.... In forum Hardware, firmware and software help |
před 10 months | |
|
Now I have a bit different problem. The filament run out and... In forum Hardware, firmware and software help |
před 10 months | |
|
Yes I did not have stl-files available because I use Prusa L... In forum Hardware, firmware and software help |
před 12 months | |
|
This is one of the three stl-files where I get those filamen... In forum Hardware, firmware and software help |
před 12 months | |
|
Filament changing bug? In forum Hardware, firmware and software help |
před 12 months |