Prusa3D Forum

Notifications

Clear all

kaouch2000

Groupe: Enregistré

A(ont) rejoint: 2022/12/01

Active Member

	Problem solved: After soldering the copper trace and finishe... Dans le forum Hardware, firmware and software help	il y a 2 years
	Latest: I reglued all loose magnets, no change so far. The s... Dans le forum Hardware, firmware and software help	il y a 2 years
	But maybe this „clickfrogging“ is a normal behaviour, I didn... Dans le forum Hardware, firmware and software help	il y a 2 years
	No, the heatbed itself stays flat. Also when I take off the ... Dans le forum Hardware, firmware and software help	il y a 2 years
	IMG_0397 I hope you can work with that 😀 Dans le forum Hardware, firmware and software help	il y a 2 years
	RE: Printshee doesn´t fully stick to heatbed Dans le forum Hardware, firmware and software help	il y a 2 years
	Hi there, thx for replying, I´ll post a video as soon as pos... Dans le forum Hardware, firmware and software help	il y a 2 years
	Or is there a need to renew all the magnets from time to tim... Dans le forum Hardware, firmware and software help	il y a 2 years
	Printshee doesn´t fully stick to heatbed Dans le forum Hardware, firmware and software help	il y a 2 years

Statistiques du forum

565 Forums

64.5 K Sujets

451.9 K Messages

26 En-ligne

71.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé