Prusa3D Forum

Notifications

Clear all

kaouch2000

Skupina: Registrovaný

Přidal se: 2022/12/01

Active Member

	Problem solved: After soldering the copper trace and finishe... In forum Hardware, firmware and software help	před 3 years
	Latest: I reglued all loose magnets, no change so far. The s... In forum Hardware, firmware and software help	před 3 years
	But maybe this „clickfrogging“ is a normal behaviour, I didn... In forum Hardware, firmware and software help	před 3 years
	No, the heatbed itself stays flat. Also when I take off the ... In forum Hardware, firmware and software help	před 3 years
	IMG_0397 I hope you can work with that 😀 In forum Hardware, firmware and software help	před 3 years
	RE: Printshee doesn´t fully stick to heatbed In forum Hardware, firmware and software help	před 3 years
	Hi there, thx for replying, I´ll post a video as soon as pos... In forum Hardware, firmware and software help	před 3 years
	Or is there a need to renew all the magnets from time to tim... In forum Hardware, firmware and software help	před 3 years
	Printshee doesn´t fully stick to heatbed In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

585 Fóra

68.3 K Témata

478.2 K Příspěvky

10 Online

76.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed