Prusa3D Forum

Notifications

Clear all

Kalimando Design

Group: Registered

Joined: 2018/10/12

New Member

	I think you might be right, when I was rebuilding it I just ... In forum Hardware, firmware and software help	4 years ago
	First layer calibration loop In forum Hardware, firmware and software help	4 years ago
	Yes I understand that, however it applies across all top or ... In forum Hardware, firmware and software help	5 years ago
	PrusaSlicer - Adjust Top/Bottom fill pattern on an individua... In forum Hardware, firmware and software help	5 years ago

Forum Statistics

565 Forums

63.8 K Topics

447.3 K Posts

21 Online

69.4 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed