Notifiche
Cancella tutti
justim
Gruppo: Registrato
Registrato: 2016/12/19
Active Member
1
|
I'm starting to think this is a power supply limitation. Ov... Nel forum Hardware, firmware and software help |
5 years fa | |
|
Hey Tim, thanks for looking at this. This is the same behavi... Nel forum Hardware, firmware and software help |
5 years fa | |
|
X Axis Stuttering Nel forum Hardware, firmware and software help |
5 years fa | |
| Just wanted to follow up: I think washing was an excellent i... | 5 years fa | |
| Thanks I wash it and try raising the temp a little Any idea ... | 5 years fa | |
| Update: The right side lifted after 30 minutes and I had to ... | 5 years fa | |
| Uneven print surface | 5 years fa | |
| Ordered 12/21/2017 and not shipped | 6 years fa |