Notifications
Clear all
Jumba
Skupina: Registrovaný
Přidal se: 2021/11/15
New Member
|
After reading some more information about it, I hadn't reali... In forum Hardware, firmware and software help |
před 3 years | |
|
I wipe down the bed between prints (after it has cooled down... In forum Hardware, firmware and software help |
před 3 years | |
|
If I put the z adjustment any lower, then the filament doesn... In forum Hardware, firmware and software help |
před 3 years | |
|
The curling only happens when printing directly on to the st... In forum Hardware, firmware and software help |
před 3 years | |
|
Print help In forum Hardware, firmware and software help |
před 3 years |