JuanCholo – Activité – Prusa3D Forum

Notifications

Clear all

JuanCholo

Groupe: Enregistré

A(ont) rejoint: 2017/01/08

Honorable Member

	i talked a little about stuff in here and here Dans le forum Print tips (Archive)	il y a 7 years
	if i remember i'll post my settings. you have to run it supe... Dans le forum Print tips (Archive)	il y a 7 years
	i forgot in my original post. when i start the print with H... Dans le forum Print tips (Archive)	il y a 7 years
	newest firmware issues required changes to print settings Dans le forum Print tips (Archive)	il y a 7 years
	oh you do have to bake it extensively before use. it absorb... Dans le forum Print tips (Archive)	il y a 8 years
	well some of the strength was obvious as i had parts complet... Dans le forum Print tips (Archive)	il y a 8 years
	i found 215 was a little too high i was having issues lots o... Dans le forum Print tips (Archive)	il y a 8 years
	you need to test your prints for strength, the default setti... Dans le forum Print tips (Archive)	il y a 8 years
	I've used vacuum bags, it becomes an issue with nylon becaus... Dans le forum Print tips (Archive)	il y a 8 years
	IMGBOX turned out to be worse then photobucket and i need to... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	i've had to start all over with my photos thanks to photobuc... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	try reducing the tension on the 2 screws that tension the Na... Dans le forum Others (Archive)	il y a 8 years
	photobucket just died for the entire world.. maybe it was t... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Re: dan's projects Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	yup razor blades are actually the best tool for removal, i p... Dans le forum Print tips (Archive)	il y a 8 years
	ok i learned if you do change the setting for the nozzle to ... Dans le forum Print tips (Archive)	il y a 8 years
	forced under extruding with slic3r? Dans le forum Print tips (Archive)	il y a 8 years
	its not hard to change but messy. for me i didn't want to t... Dans le forum Print tips (Archive)	il y a 8 years
	yup they will go away on the next bed heatup,, you can move ... Dans le forum Print tips (Archive)	il y a 8 years
	double check the bed heat sensor under the machine that it d... Dans le forum Print tips (Archive)	il y a 8 years

Page 23 / 27 Précédent Suivant

Statistiques du forum

565 Forums

63.9 K Sujets

447.8 K Messages

21 En-ligne

69.6 K Membres

Le dernier des messages: Filament leak? Notre nouveau membre: Mechman0124 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé