Čeština
Fóra
Uživatelé
JuanCholo
Aktivita
 
Notifications
Clear all
JuanCholo
JuanCholo
Skupina: Registrovaný
Přidal se: 2017/01/08
Honorable Member
1
Profile Aktivita
yup attempting the settings on my yellow filament from your ...

In forum Others (Archive)

 před 6 years
what i like to do is i mark the position of the bolts with a...

In forum Assembly and first prints troubleshooting

 před 6 years
so yellow is as problematic as people had stated. 2 jams so ...

In forum Assembly and first prints troubleshooting

 před 6 years
was worth a shot. i guess the best manual solution would be...

In forum Assembly and first prints troubleshooting

 před 6 years
2 biggest things i want to fix 1) stringing, i'm reading on...

In forum Others (Archive)

 před 6 years
had first real failure on a print. was caused by the yellow ...

In forum Assembly and first prints troubleshooting

 před 6 years
it could be static; it is possible to just run a static dis...

In forum General discussion, announcements and releases

 před 6 years
my observations on an enclosure: you need them. the machine...

In forum Hardware, firmware and software help

 před 6 years
trudging up the same paths as everyone i got these so far

In forum Others (Archive)

 před 6 years
awesome thanks!

In forum Assembly and first prints troubleshooting

 před 6 years
check the STL file. i've had situations where the output fr...

In forum General discussion, announcements and releases

 před 6 years
Thanks for the info Daniel, sounds like more hell than i was...

In forum General discussion, announcements and releases

 před 6 years
my feed back from before MMU2.0 in just using the MK3. tur...

In forum Hardware, firmware and software help

 před 6 years
it isn't related to the MMU at all. since almost the first d...

In forum General discussion, announcements and releases

 před 6 years
i read a little more on the sensor. the sensor is only in us...

In forum Assembly and first prints troubleshooting

 před 6 years
well i have to say that was pretty amazing. some of my...

In forum Assembly and first prints troubleshooting

 před 6 years
i got the lizard out. and decided to go for a real test with...

In forum Assembly and first prints troubleshooting

 před 6 years
ok, turned it off then.

In forum Assembly and first prints troubleshooting

 před 6 years
Filament sensor question.

In forum Assembly and first prints troubleshooting

 před 6 years
funny enough i didn't read the forums at all. i wanted an un...

In forum Assembly and first prints troubleshooting

 před 6 years
Stránka 16 / 27
Share: