Notifications
Clear all
joshua.r4
Skupina: Registrovaný
Přidal se: 2017/08/14
Active Member
1
|
@peter-m26 Thanks for the suggestions. I clean the bed with ... In forum How do I print this? (Printing help) |
před 4 years | |
|
Prints curling and detaching from build plate In forum How do I print this? (Printing help) |
před 4 years | |
|
I am printing from the SD Card. I am using the Slcer program... In forum Print tips (Archive) |
před 7 years | |
|
OK, after looking at it I found that it was overextruding. I... In forum Print tips (Archive) |
před 7 years | |
|
Thank you so much for pointing me in the right direction. I ... In forum Print tips (Archive) |
před 7 years | |
|
Ok, I will try it again. Thanks for your help.
In the meant... In forum Print tips (Archive) |
před 7 years | |
|
I have tried adjusting the Z axis without much improvement. ... In forum Print tips (Archive) |
před 7 years | |
|
I just pulled the print off and noticed some pretty signific... In forum Print tips (Archive) |
před 7 years | |
|
First layer adhesion issue In forum Print tips (Archive) |
před 7 years |