Prusa3D Forum

Notifiche

Cancella tutti

Josh

Gruppo: Registrato

Registrato: 2022/01/16

Active Member

	Yeah, I didn't have any problems with first layers or any si... Nel forum Hardware, firmware and software help	3 years fa
	Thanks for your help. It wasn't the amount of infill unfortu... Nel forum Hardware, firmware and software help	3 years fa
	Thanks for your input @neophyl but I think the real problem ... Nel forum Hardware, firmware and software help	3 years fa
	I tried adaptive cubic infill and it was much worse: This ... Nel forum Hardware, firmware and software help	3 years fa
	Ok, but none of this has changed... So it doesn't make sense... Nel forum Hardware, firmware and software help	3 years fa
	RE: Sudden top layer problems Nel forum Hardware, firmware and software help	3 years fa
	Sudden top layer problems Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

566 Forum

63.2 K Discussioni

444.2 K Post

24 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso