Prusa3D Forum

Notifications

Clear all

Josh

Grupa: PreRegistered

Dołączył: 2023/09/12

Tytuł: Member

	Probably an obvious solution, but did you make sure the nozz... In forum Hardware, firmware and software help	1 year temu
	After reset, the successive prints were globbing up like the... In forum Hardware, firmware and software help	1 year temu
	Doesn’t seem to be… the prints are acting like the Z height ... In forum Hardware, firmware and software help	1 year temu
	Z height too low on textured sheet In forum Hardware, firmware and software help	1 year temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.3 K Posty

22 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte