Notifications
Clear all
Jorge Martinez
Group: Registered
Joined: 2016/06/28
Active Member
1
|
Random layer not adhering. Curling in strips. In forum Prusa i3 kit (Archive) |
9 years ago | |
| Have you tried going to calibration -> then Autohome? If ... | 9 years ago | |
|
Some more photos - checking if it's a software glitch. I thi... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Heatbed issue, seltest OK, but no heat while printing In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Printing on different beds/thick acrylic sheet In forum Print tips (Archive) |
9 years ago | |
|
I was reading this post and decided to check my prints and I... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Well I think it is the point where the print was stopped and... In forum Print tips (Archive) |
9 years ago | |
|
Thermal Runaway error In forum Print tips (Archive) |
9 years ago |