Prusa3D Forum

Notifications

Clear all

JordonMusser

Groupe: Enregistré

A(ont) rejoint: 2021/10/25

Active Member

	Thanks for the tips. Makes sense. Ran PTEG last night and ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	i see the cylinder you created to support the leg, it shows ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Im thinking it has such a small surface area to adhere to th... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Everything performed perfectly except this hiccup on the leg... Dans le forum How do I print this? (Printing help)	il y a 3 years
	PLA is correct, I intend to later print in PETG after final ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	wow awesome thank you! Dans le forum How do I print this? (Printing help)	il y a 3 years
	I printed the little benchy boat and it printed perfectly. ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Sorry for the super slow responses. I reply quickly but I g... Dans le forum How do I print this? (Printing help)	il y a 3 years
	For sure its not a bed adhesion issue. sucker is stuck on t... Dans le forum How do I print this? (Printing help)	il y a 3 years
	no doubt. Although the print seems to work well with out th... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Overhang problem? Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

20 En-ligne

67.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé