Prusa3D Forum

Benachrichtigungen

Alles löschen

Jono

Gruppe: Registriert

Beigetreten: 2015/09/10

Active Member

	That is this thread. I've declared a need for a MK2 hotend a... Im Forum General discussion, announcements and releases	Vor 5 years
	Proposal for an official Spare Part Swap forum Im Forum General discussion, announcements and releases	Vor 5 years
	Advice on MK2 hotend replacement and whether/when to upgrade Im Forum General discussion, announcements and releases	Vor 5 years
	Very good points! Looking at my Mk2, it looks like there is ... Im Forum Hardware, firmware and software help	Vor 6 years
	Mine isn't visibly damaged, but the temperature reading drif... Im Forum Hardware, firmware and software help	Vor 6 years
	I finally managed to print the first few layers of an object... Im Forum Print tips (Archive)	Vor 8 years
	Ack, sorry to see that Thomas. It's far too easy for any of ... Im Forum Print tips (Archive)	Vor 8 years
	Tips for Flexible Filaments on MK2 Im Forum Print tips (Archive)	Vor 8 years
	So what's the state of support for the socks for a MK2 upgra... Im Forum Improvements (Archive)	Vor 8 years
	Kirk, try loosening the springs on the drive gear. It should... Im Forum Others (Archive)	Vor 8 years
	I got a beautiful ninjaflex print the first try on my mk2. U... Im Forum Others (Archive)	Vor 8 years
	per-filament gcode to adjust z offset Im Forum Improvements (Archive)	Vor 8 years
	Thanks for the help! That configuration worked perfectly for... Im Forum Software (Archive)	Vor 8 years
	Can someone please hold my hand through setting this up? I b... Im Forum Software (Archive)	Vor 8 years

Forums-Statistiken

559 Foren

62.9 K Themen

443 K Beiträge

25 Online

67.7 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen